Can't change Default Emulator Video Mode or Emulator + ROM Video Mode in Run Command

jonnykesh · 11 Dec 2017, 11:03

@mcmayhem it would just skip down to the next line. The process happens in the background. Did you try rebooting after you ran this before testing?

mcmayhem · 11 Dec 2017, 13:29

@jonnykesh My apologies for the delayed response.

Yes, I rebooted it afterwards. Same problem. Any other ideas?

jonnykesh · 11 Dec 2017, 13:37

@mcmayhem It could be possible your card may have gone to read-only. Try adding a few random files or folders, then reboot and see if they are still there. Just to rule this out as a possibility.

mcmayhem · 11 Dec 2017, 15:44

@jonnykesh I added dosbox and a few ROMs I'd been intending to add...they stayed on the system just fine.

mcmayhem · 12 Dec 2017, 01:30

@jonnykesh Any other thoughts on what this could be? I suppose I could just wipe the card and start over, but I really don't want to go through the hassle of all that - especially if it could just end up happening again, y'know?

chipsnblip · 12 Dec 2017, 05:25

check the output of this command:

ls -l /opt/retropie/configs/all/videomodes.cfg

it should read:

-rw-r--r-- 1 pi pi

mcmayhem · 13 Dec 2017, 02:55

@chipsnblip Tried it, didn't get that result. Pi gave me this -

mitu · 13 Dec 2017, 05:23

@mcmayhem You used '-1' (one), but the command has '-l' (lowecase L). This should display the permissions on the file, similar to the output shown by @chipsnblip.

chipsnblip · 13 Dec 2017, 06:23

@chipsnblip said in Can't change Default Emulator Video Mode or Emulator + ROM Video Mode in Run Command:

ls -l /opt/retropie/configs/all/videomodes.cfg

since the screen is cut off a bit, add some spaces to the output so we can see it:

ls -l /opt/retropie/configs/all/videomodes.cfg | sed 's/^/   /'

note there are 3 spaces in between the forward slashes at the end of that command

mcmayhem · 15 Dec 2017, 15:22

@mitu @chipsnblip Hahaha, wow. How embarrassing. Thanks, I will try this and report back.