ps4 controller setup... retropie now wont get passed loading screen.

[tim281080]

Sorry the link to the image is below.

[tim281080]

This was the tutorial i followed.

https://github.com/retropie/retropie-setup/wiki/PS4-Controller#userspace-controller-driver-ds4drv

[mitu]

You don't need ds4drv to pair your controller, just pair it as a normal Bluetooth controller and forget about ds4drv.

[tim281080]

@mitu Hello, Yeh I tried that but it didnt work.

However, I cant even get retro pie to load back now as its locked on this screen and wont let me boot up.

[mitu]

@tim281080 You'll need a keyboard to be able to start Emulationstation and run the RetroPie-Setup to pair your controller. If you don't have one, then enable SSH and connect to your PI remotely from a PC - you can then run the setup from the command line.

[tim281080]

Yeh Ive got a keyboard, but no commands work on this screen that i get too.

Basically, i power up. 10 seconds later this screen appears and then just sits there. I can type but nothing works.

Is there a command i can use from this screen to get back to emulation station?

[mitu]

@tim281080 What does the screen say ?

[tim281080]

[mitu]

@tim281080 I advise you to re-flash your card and start anew, then follow the normal Bluetooth pairing method, without installing any additional drivers. If you still have problems, report them here.

[tim281080]

@mitu ok thanks for your help.

[BuZz]

probably incorrectly edited /etc/rc.local - did you forget the & on the end ? could ssh in and remove the line you added perhaps.

[tim281080]

Hello,

Quick update. I re-flashed and figured it out.

The problem was that i had the PS3 controller driver enabled and this was disconnecting the ps4 controller after it had synced up as they don't work together.

So i disabled the ps3 driver and then just blue-toothed the PS4 pad the normal way (without the DS4 driver) and it works perfectly.

Thanks for your help.