DIY Spinner
-
@UDb23 Sorry to revive this old thread, but is there a possibility you could share the stl files? for v2? I am currently making a spinner and I think the knob is exactly what I am looking for!
-
@UDb23 Do you have a link where I can order the bearing?
Did I understand correctly?
You stuck black paper on the bottom?
Without cutouts?Edit:
I found, sorry (KFL08 8mm) -
@shantigilbert Think I still got the files; let me check.
-
@treki I cut out the cardboard to have more or less the same shape of the round moving bottom part of the bearing.
-
@UDb23 Sorry, my english is terrible. I not understand exactly....
(I cut out the cardboard to have more or less the same shape of the round moving bottom part of the bearing.)
Do you have a photo?
I order:
https://de.aliexpress.com/item/4001214317907.html
https://de.aliexpress.com/item/32713267462.html
https://de.aliexpress.com/item/33036805774.html
and I use a cheap optical mouse from pearl.ch
Is this ok?My bartop: https://www.ltspiceusers.ch/threads/arcade-bartop-im-selbstbau.457
-
@treki Cardboard should be applied like this (red area)
If the knob and bar you bought are fitting the bearing they look good to go.
-
@UDb23 said in DIY Spinner:
Cardboard should be applied like this (red area)
No lamella needed? The optical mouse understood this like a black table?
Cool ^^ -
@treki Yes. Just make sure cardboard is not too thick; should be able to rotate freely.
-
@UDb23 said in DIY Spinner:
Yes. Just make sure cardboard is not too thick; should be able to rotate freely.
That is clear. Thank you
Bombastic idea from you ^^https://de.aliexpress.com/item/1005001309430437.html
The chinese says: No support for Raspberry :(Can I then ask you if I have a issues?
PS:
www.ltspiceusers.ch is my own forum. Is for LTspice and electronics (german).
You are welcome for register. -
@treki said in DIY Spinner:
The chinese says: No support for Raspberry :(
Can I then ask you if I have a issues?It seems that needs a specific arcade1up controller; without it won't work.
-
@shantigilbert
here you got my 3d source files. Have fun! -
-
ATM I willbuild a new control.E-Limitatot......Sanwa ist switchet to GND!
A normaly circuit is GND to Joxsticj etc
-
Guy over on AtariAge did 2 sets of these already and is working on a 3rd set now. I bought one of each run and they work great. :)
-
I order
https://www.campz.ch/mcnett-aquapak-epoxy-reparaturharz-236208.html
Is this ok? -
It works ^^
I soldered 2 wires for the button.
-
Thx for this idea/tutorial ^^
-
@treki hi, can you tell me what is wires red and black? Thanks
-
@UDb23 this is great! How use this with a zero delay usb card? Thanks
-
@calom said in DIY Spinner:
@treki hi, can you tell me what is wires red and black? Thanks
These are for the (external) button.
At Arkanoid, this releases the ball.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.