(Solved) Pi5 : USB audio issue

DTEAM

Not yet. What I got for now. I'll do a test

pi@retropie:~ $ pi@retropie:~ $ amixer scontrols -D default
Simple mixer control 'Master',0
Simple mixer control 'Capture',0
pi@retropie:~ $ amixer scontrols -D sysdefault
Simple mixer control 'Headphone',0
pi@retropie:~ $ amixer scontrols -D hw
Simple mixer control 'Headphone',0

pi@raspberrypi:~ $ amixer scontrols -D audio doesn't work. I must use preset value like default.
audio = my audiocard

DTEAM

@mitu said in Pi5 : USB audio issue:

Do you get audio in emulators or using the ALSA speakter-test utility ?

No sound for both

Does dtparam affect it?

# Enable audio (loads snd_bcm2835)
dtparam=audio=on

mitu

@DTEAM said in Pi5 : USB audio issue:

Does dtparam affect it?

No. In fact almost all of the video/audio related params you added have the effect as they did before.

No sound for both

Did you remove any ALSA configuration ? What's the out[put ofspeaker-test ?

DTEAM

@mitu said in Pi5 : USB audio issue:

Did you remove any ALSA configuration ? What's the out[put ofspeaker-test ?

yes

with card = default and device = master (seems to be the good combo.... but no sound )

https://pastebin.com/hf8Na64X

mitu

@DTEAM I don't see an error in speaker-test output. Make sure the output isn't muted by any chance.

DTEAM

@mitu

How can I see if it's muted or not ? The sound level is always at 100% in the EmulationStation UI or in the alsamixer UI

mitu

@DTEAM in alsamixer, the muted state is printed with an M underneath the volume slider. You can toggle the muted state by pressing m.

DTEAM

@mitu

Good news, It finally worked, It was on mute by default (I didn't use my keyboard in Alsamixer).

But now I have a new problem. I played with pulse audio in my "Audio UI" and now my Pi freeze all the time and I have no sound and no video. How can I reactivate Pulse Audio (now enable to create stream) . I already used "Reset to default" but nothing change. I lost options in my UI with my mess.

How can I reset my audio setup

mitu

@DTEAM said in Pi5 : USB audio issue:

I already used "Reset to default" but nothing change.

Reset to default I think only applies to the ALSA settings and just removes any RetroPie configuration file. In your case, it's not going to do anything, since RetroPie didn't configure your USB gamepad.

I lost options in my UI with my mess.

No idea, try to remove the packages you've installed and reboot.

DTEAM

@mitu
It works again. I re-install PipeWire and AudioPulse from rasPi config and everything works great. thanks for your support