Sony DualShock 3 - call for testers: "sixaxis" script module
-
@Headcrab said in Sony DualShock 3 - call for testers: "sixaxis" script module:
I did not mean that i first unnecessarily enabled third party support.
By default, support for 3rd party controller is not installed - when you choose
Enable 3rd party controller support
, an additional package is installed. When you chooseDisable ..
that additional package is uninstalled. So it's not like an option for the driver.Can you check by re-installing the
sixaxis
driver ? This will not remove your existing gamepad configurations. -
@mitu
While using the ps3 controller over bluetooth, i removed the sixaxis package and rebooted.
The controller remained functional even after the reboot. (i'm confused by this)Then i reinstalled sixaxis from source, and the controller remains functional like before. The controller was already paired.
To be clear, during all this process i used the ps3 controller over bt.Maybe i need to check on a fresh install, if the "thrid party support" additional package is installed by default?
What should i be looking for? -
@Headcrab said in Sony DualShock 3 - call for testers: "sixaxis" script module:
Maybe i need to check on a fresh install, if the "thrid party support" additional package is installed by default?
What should i be looking for?Normally, 3rd party controller installs also the
customhidsony
driver package. So you can see in the list of packages from the drivers section if something new gets installed after installingsixaxis
. Of course, the normal test to see if after the installation that the controller works without issues and you don't need to use the 'Disable 3rd party controller support', would be ideal.Thanks for testing.
-
I've done some more testing (i probably erased and burned the SD card about 10 times today)
So i will do a recap.The problem
When trying to pair an official ps3 controller for the first time, it is not being discovered.
I get the message "No devices were found. Ensure device is on and try again"The steps
- Burn the "retropie-buster-4.6-rpi2_rpi3.img" image on the sd card
- boot into emulationstation
- connect ps3 controller over usb and configure controls, so i can navigate
- go to driver packages and install sixaxis
- reboot
- with the controller connected over usb navigate to Bluetooth > "Register and Connect to Bluetooth Device"
- follow the instructions to unplug and re-plug the cable (and leave it connected)
- it fails to discover the controller
I confirmed that customhidsony is not installed after installing sixaxis.
It does not show up in the driver menu. Also :ls -la /opt/retropie/supplementary/ total 52 drwxr-xr-x 13 root root 4096 May 1 12:51 . drwxr-xr-x 7 root root 4096 May 1 12:50 .. drwxr-xr-x 2 root root 4096 Apr 28 01:15 bashwelcometweak drwxr-xr-x 4 root root 4096 Apr 28 01:08 emulationstation drwxr-xr-x 2 root root 4096 Apr 28 01:09 mesa-drm drwxr-xr-x 2 root root 4096 Apr 28 01:12 omxiv drwxr-xr-x 2 root root 4096 Apr 28 01:08 retropiemenu drwxr-xr-x 3 root root 4096 Apr 28 01:09 runcommand drwxr-xr-x 2 root root 4096 Apr 28 01:05 sdl2 drwxr-xr-x 2 root root 4096 May 1 12:51 sixaxis drwxr-xr-x 3 root root 4096 May 1 12:50 splashscreen drwxr-xr-x 2 root root 4096 Apr 28 01:14 usbromservice drwxr-xr-x 4 root root 4096 Apr 28 01:17 xpad
If i hit the "disable third party support" option, i've found through the log that the following packages are installed:
The following NEW packages will be installed: libbluetooth-dev libbluetooth3
After a reboot i am able to pair my controller, but even then it is not solving the discovery problem every time.
For example i had to switch to my other rpi3 board to make the controller discoverable in one of my tries. -
@Headcrab said in Sony DualShock 3 - call for testers: "sixaxis" script module:
follow the instructions to unplug and re-plug the cable (and leave it connected)
it fails to discover the controllerYou don't need to reboot after the installation of the driver. Did you press the 'PS/Share' button before dis-connecting ?
-
@mitu
I tried one more fresh install, just to make sure.
I am pressing the PS/Share' button before dis-connecting.It is consistently not discovering the controller after installing the sixaxis driver.
Doing the "disable thrid party" option and rebooting works 99% of the time. -
Thanks for testing - I'll add a note in the wiki for this.
-
@mitu
Thanks for your time.
I hope we get confirmation from other ps3 controller owners at some point. -
On my pi3b+ with retropie 4.6 on debian 9.11 wont worked, i made the same process...
-
@wmarcio said in Sony DualShock 3 - call for testers: "sixaxis" script module:
On my pi3b+ with retropie 4.6 on debian 9.11 wont worked, i made the same process...
You're using a 3rd party controller, did you run the 'Enable 3rd party controllers' step ?
-
I've done some more testing, and found out that libbluetooth-dev does the trick.
So for the official ps3 controller these are the steps that work on my end.- install sixaxis driver
- sudo apt-get install libbluetooth-dev
- reboot
- Connect the controller over usb
- Bluetooth menu > "Register and Connect to Bluetooth Device"
- Follow the on screen instructions
-
@Headcrab said in Sony DualShock 3 - call for testers: "sixaxis" script module:
I've done some more testing, and found out that libbluetooth-dev does the trick.
I think that's a red herring, the package contains only development files, without any impact on the Bluetooth stack that's running on the Pi.
EDIT: Hm, actually it seems to contain more than that. I'll take a look, but on my system this is not installed and the controller works ok.
-
@mitu
My findings are not based on actual knowledge of what each package does, so you are probably right.But just to be clear, when you say that your controller works fine do you mean that when trying to Register for the first time, it is being discovered without that package being installed?
-
@Headcrab said in Sony DualShock 3 - call for testers: "sixaxis" script module:
But just to be clear, when you say that your controller works fine do you mean that when trying to Register for the first time, it is being discovered without that package?
I never had that package installed and it's not installed now, so yes - discovery and (now) basic controller functionality worked without it. There might by a difference between systems though, I've paired and connected on a Pi4, which has a different BT chipset, so you being on a Pi3B+ might count.
-
@mitu said in Sony DualShock 3 - call for testers: "sixaxis" script module:
I've paired and connected on a Pi4, which has a different BT chipset, so you being on a Pi3B+ might count.
I just "borrowed" a rpi4(1gb) from my nas setup so i can test this.
I performed these steps:
- Burn the "retropie-buster-4.6-rpi4.img" image on the sd card
- boot into emulationstation
- connect ps3 controller over usb and configure controls, so i can navigate
- go to driver packages and install sixaxis
- with the controller connected over usb navigate to Bluetooth > "Register and Connect to Bluetooth Device"
- follow the instructions to unplug and re-plug the cable (and leave it connected)
The outcome was exactly like on my rpi3.
- Discovery fails.
- If i install libbluetooth-dev and reboot
- Discovery succeeds
Maybe it's a problem with my controller, i don't know.
Also, i do not own a ps3 console, so it is not interfering in any way. -
@mitu, Hello, thank you, you are always helping people. My controller is original Sony, I always used the same controller, before upgrading to version 4.6, the same controller worked perfectly.
-
@wmarcio What version did you run before the upgrade ? Did you install the 4.6 Buster image ? Did you enable support for 3rd party controllers ?
-
I don't remember the previous version exactly, but I always update frequently, it was the last one before I upgraded to 4.6. Yes I did a clean installation for version 4.6 Buster, as I saw that it didn't work, I restored the previous image of raspbian 9.11 stretch and Retropie 4.6, that's when the problem started. Yes, I have enabled support for third party control.
-
@wmarcio said in Sony DualShock 3 - call for testers: "sixaxis" script module:
I don't remember the previous version exactly, but I always update frequently, it was the last one before I upgraded to 4.6.
There's no difference between the previous (4.5.20) and the 4.6 version, except the version tag. There have been no modifications in quite a while for the bluetooth module in RetroPie, so I don't see what change in 4.6 might trigger this problem.
Yes I did a clean installation for version 4.6 Buster, as I saw that it didn't work, I restored the previous image of raspbian 9.11 stretch and Retropie 4.6, that's when the problem started. Yes, I have enabled support for third party control.
Then I suggest you try the
ps3controller
package, it might work better with 3rd party controllers. -
@mitu ok, will try It. Thxs again.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.