Stratus xl works fine in ES, but nowhere else.

mitu

@pwd847 said in Stratus xl works fine in ES, but nowhere else.:

but the instructions are outdated and there is no "Setup" option and there is no "Configure joystick/controller for use with RetroArch" option.

That section is specifically for older versions. Don't go modifying the docs if you don't know what you're doing.
Please add more information about your system, as requested in https://retropie.org.uk/forum/topic/3/read-this-first.

pwd847

Pi 3
Canakit 5 V 2.5 A power supply
RetroPie 4.4
Built From: Pre made SD Image on RetroPie website,
USB Devices connected: keyboard
Controller used: stratus xl
Emulator: SNES

mitu

Does your controller have a mode switch to choose between connecting to a PC or Android device ? Did you map the Hotkey button during the Input configuration in Emulationstation ?

pwd847

No mode switch. I tried once mapping the hotkey, and another time not mapping the hotkey and assigning it to select. A few mins ago I was able to get into the retroarch bind menu by using a combination of the keyboard and the controller, but even after mapping the buttons, the same results occur.

mitu

Try using the sdl input driver - since you say it works in Emulationstation. The input configuration has created a configuration file for RetroArch to read. It's in /opt/retropie/configs/all/retroarch-joypads. Open it and replace the

input_driver = udev

with

input_driver=sdl

You don't need to restart anything, just try again to start a SNES game.

pwd847

I just reset to a fresh install. I brought the system back to where it was before. Connected to wifi, gamepad is detected via bluetooth and configured correctly in ES.

I modified the .cfg file and the exact same things happened as before.

Within retroarch the D-pad is binded correctly and my Start button is binded to my "left shoulder" button. None of the other buttons do anything at all.

pwd847

I paired an xbox one controller a few mins ago and same thing. I can configure the xbox controller in ES and it works fine until I load an SNES game. Then no buttons work.

mitu

@pwd847 said in Stratus xl works fine in ES, but nowhere else.:

I paired an xbox one controller a few mins ago and same thing. I can configure the xbox controller in ES and it works fine until I load an SNES game. Then no buttons work.

Aha. Can you try reinstalling the xpad driver for Xbox based controllers ? You need to restart after reinstalling the driver and then re-configure the input in Emulationstation.

pwd847

Before you replied I did

Sudo apt update
Sudo apt upgrade
Sudo rpi-update
Sudo apt autoremove

I noticed during the

Sudo apt upgrade

The xpad driver was updated.

pwd847

according to sdl2_jstest, I have a bunch of buttons that are not recognized...