Please do not post a support request without first reading and following the advice in

Control Help Please

  • I'm still very new to the raspberry pi thing, I've setup emulation and front ends on PC with launchbox without much issue. But I'm struggling to figure this one out. I have my pi up and running with attract mode, everything seems good, except I can't get the arcade control panel I built to work properly with it, I know it functions as a keyboard, but I can't get my key binds to save and I'm not sure what I'm doing wrong. I read through the retroarch config stuff and I can't seem to figure it out. I want to be able to go into each console and configure them separately. I've done everything I can think of or that I've found online and can't seem to figure it out. Any help would be greatly appreciated.


  • Global Moderator

    Can you add more info about your system, as requested in ? What type of controller are you using ? You might want to switch to Emulationstation as frontend and configure it, since this will also generate a gamepad auto-configuration for RetroArch.

Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.

Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.