Please do not post a support request without first reading and following the advice in https://retropie.org.uk/forum/topic/3/read-this-first

Xin-mo two players



  • Hi everyboy,
    I have installed xinmotek controller dual player in my raspberry pi3. I added the line in the boot/cmdline.txt and indeed it has been detected correctly. When I try to configure the joystick in emustation using the configure input menu, I correctly see gamepad 1 when I bind buttons and joystick to player 1 and the same for gamepad 2 for player 2.
    Once i finished I can move the menu and go in and out with both joystick, but when I reboot the Pi or try to play at any games, the first joystick I bind it's kinda loose the configuration and it works only the last one configured. I'm really lost please help
    thanks a lot for any good advices


  • Global Moderator

    @nibe The 2 gamepads share the same configuration - it's enough to configure 1, the 2nd will get the same config. If you re-configure one of the players, the other one will be configured similarly - there's only 1 config for both players.

    EDIT: This applies to any Libretro (RetroArch) based emulator.



  • @nibe as @mitu stated you only need to configure one controller. However if after reboot player one is messed up it means you didnt wire up both players identical.



  • thanks guys indeed now it works thanks again



Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.

Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.