Disable Analog with config.txt

Brotatochip

So I accidentally enabled analog output in the pi4 settings and I don't have a place to display it so I was wondering how to disable it with the config.txt. I would like it to be an HDMI output.

mitu

Remove/comment the line with enable_tvout from config.txt and it should disable the composite video output.

Brotatochip

@mitu so that kinda works it displays the color splash screen the some code then no signal and the code is in the top left corner.

mitu

@Brotatochip Please add more info about your setup - including the TV model/resolution. See https://retropie.org.uk/forum/topic/3/read-this-first.

Did it worked correctly before you used raspi-config to change the tv out settings ? Can you post your config.txt file ?

Brotatochip

@mitu Before it worked fine no problems and I'm using a 1080I Visio tv I get the config file soon

Brotatochip

Here is the config file(note this is not in the config file)

# For more options and information see
# http://rpf.io/configtxt
# Some settings may impact device functionality. See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
over_voltage=2
arm_freq=1750

# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable infrared communication.
#dtoverlay=gpio-ir,gpio_pin=17
#dtoverlay=gpio-ir-tx,gpio_pin=18

# Additional overlays and parameters are documented /boot/overlays/README

# Enable audio (loads snd_bcm2835)
dtparam=audio=on

[pi4]
# Enable DRM VC4 V3D driver on top of the dispmanx display stack
dtoverlay=vc4-fkms-v3d
max_framebuffers=2

[all]
#dtoverlay=vc4-fkms-v3d
overscan_scale=1

Brotatochip

Sorry took so long but thanks it worked amazing you are the best.