iPac 2 on Mac. Error using MaciPac utility
-
Howdy folks. My wonderful luck in life has me stuck yet again with a problem not seen on this entire planet, according to searches on Google and everywhere else on the internets. So, I launch the utility MaciPac (downloaded from Ultimarc), plug in my iPac2 board. Then when I go to re-configure a button, say...1SW1 to R, I get an error saying Upload Failed to Start. MacIPAC was unable to start the upload. Please try again.
Lovely.
Has anyone else received this error and found a solution?Much appreciation.
-
This was something I experienced a few years back so take this solution as a maybe.
I ran into two issues with the iPac that I ended up using for a VPin:
1 - It could not get new assignments in the Mac version of the program
2 - I could not flip it over to the alternate firmware to allow joystick inputsI found that I needed to update to the most recent firmware from a PC and assign inputs there. Once that was all done I was able to access it from the Mac side. Unsure what fixed it along the way though.
A VM won't always work so do a boot camp if you can.
Hope that gets you a step further!
-
@thetraingoes Yeahhhh im about to try Wineskin for the PC version. Thanks for at least replying.
cheers
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.