RetroPie forum home
    • Recent
    • Tags
    • Popular
    • Home
    • Docs
    • Register
    • Login
    Please do not post a support request without first reading and following the advice in https://retropie.org.uk/forum/topic/3/read-this-first

    Nintendo Switch Online SNES Controller Connected but no Inputs

    Scheduled Pinned Locked Moved
    Help and Support
    nintendo configuration bluetooth contr
    4
    6
    514
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • D
      duckityduck64
      last edited by duckityduck64

      SOLVED

      I'm pretty new to Retro Pie and using Linux based software however when it comes to connecting my controller I am completely lost. I already installed dkms-hid-nintendo and Joycond following the tutorial on connecting Switch Controllers however when I tried to register inputs on the Configure Inputs screen, it stated no controllers connected. I got it to work once around right after I connected it but when I tried reconnecting it after a shutdown it would not connect any more. The Bluetooth is connected for sure and I tried disconnecting and reconnecting it with no success. Should I just re-flash Retro Pie and start from scratch or should I try something else? Any help is greatly appreciated.

      P 1 Reply Last reply Reply Quote 0
      • P
        Protocultor @duckityduck64
        last edited by

        Have you tried it wired? Do the lights start "blinking side to side" when you plug it? At that moment, you have to press both L + R buttons, to pair the controller to your system.
        Its a necessity of joycond to identify and separate dual joycons vs single ones.
        If it works wired, then you can try to connect it again using bluetooth. Remember that you have to pair it, every time you connect it to your system.

        D 1 Reply Last reply Reply Quote 0
        • D
          duckityduck64 @Protocultor
          last edited by

          @Protocultor I just tried that and the controller does do the light flash from side to side continuously when it is connected VIA Bluetooth. When I go into Bluetooth settings it is shown there but when I try to configure the inputs it says no gamepads detected. When I wired it it still didn't work. I am using a Raspberry Pi 3b if that helps.

          1 Reply Last reply Reply Quote 0
          • mituM
            mitu Global Moderator
            last edited by mitu

            Try installing the hid-nx drivers instead, the hid-nintendo is mainly meant for Switch/Joycons controllers.

            D 1 Reply Last reply Reply Quote 1
            • D
              duckityduck64 @mitu
              last edited by

              @mitu After trying to fight installing things for the past hour, I am so glad to say it worked! Thank you!

              1 Reply Last reply Reply Quote 0
              • D
                Dopedtoinfinity
                last edited by Dopedtoinfinity

                After trying a few times, and it crashed my pi, it finally just worked, and I was able to map the buttons in emulationstation. The light will always move from left to right at the bottom of the pad, but it seems to work fine (for now).

                1 Reply Last reply Reply Quote 0
                • First post
                  Last post

                Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.

                Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.