Pi 3 - Logitech F710

KC93

Wireless Logitech F710 controller isn't being recognized in input config in Emulation Station.

I've tried rebooting. Tried making sure usb dongle for new 710 controller is in top left ("player 1" usb port)....
Have used both my wired Logitech F310 and my wireless keyboard to open up input config in Emulation Station....tried switching X & D modes on the new Logitech F710....
Nothing has worked thus far.

What am I doing wrong here?

Pi 3
Retropie 4.8.9

Any help is greatly appreciated!
Thanks

RapidEdwin08

@KC93 Try installing the xpad driver from retropie setup.

KC93

@RapidEdwin08 said in Pi 3 - Logitech F710:

@KC93 Try installing the xpad driver from retropie setup.

It was already installed by source. Removed it and reinstalled by source. Rebooted.
Having same issue.

Just to clarify, the F710 is "detected" in Emulation Station but pushing any buttons on it doesn't start the configure process.

RapidEdwin08

@KC93 There's a small switch top center of the game pad, O - X.
If I recall, the O is for old school Driver mode, the X is for newer driver mode.
Try to flip the switch to X if not already.

KC93

@RapidEdwin08 said in Pi 3 - Logitech F710:

@KC93 There's a small switch top center of the game pad, O - X.
If I recall, the O is for old school Driver mode, the X is for newer driver mode.
Try to flip the switch to X if not already.

Tried that at the beginning. Thanks man, I appreciate it though!
Unfortunately not changing anything.

mitu

Can you run the following commands (with just the the F710 controller connected) and post the output:

cat /proc/bus/input/devices
lsusb

Is the controller working with a normal PC ? Does it have fresh batteries ?

You can checked whether any inputs are generated by the Linux drives with jstest , run jstest /dev/input/js0 and press the inputs (buttons/triggers/joysticks) to see if anything registers on the screen. Make sure the F710 is the only controller connected otherwise the joystick device number is different. You can interrupt the test at any time by entering Ctrl + C.