ControlBlock - Making sure that SPI interface is enabled

[stenem]

Hello
When i try to install ControlBlock everytime it will stop at Making sure that SPI interface is enabled and then nothing will happen anymore

What can I do?
thanks

[mitu]

Looks like the command that's timing out is the systemd service installation. Have you tried installing from the RetroPie-Setup, as a package from the drivers's section ?

[stenem]

@mitu I followed this guide https://github.com/petrockblog/ControlBlockService2#controlblockservice2
with the Quick Installation

and I use the os from the Rasperberry Pi imager "RetroPie 4.9 (RPI 4/400)

Do you mean via like this? https://retropie.org.uk/docs/Updating-RetroPie/

[mitu]

@stenem said in ControlBlock - Making sure that SPI interface is enabled:

Do you mean via like this? https://retropie.org.uk/docs/Updating-RetroPie/

Yes, via the RetroPie-Setup script.

[stenem]

@mitu I get the same error / timeout

[mitu]

Then I don't know what may cause this - maybe the service tries to contact/connect to the PCB after start and it times out ?
@petrockblog would know more.

[petrockblog]

Sorry for this delayed reply.

What does the ControlBlock installation do, if you you run the ControlBlock installation directly from the command line via

wget -O - https://raw.githubusercontent.com/petrockblog/ControlBlockService2/master/install.sh | sudo bash

(see https://github.com/petrockblog/ControlBlockService2#quick-installation)

Do you observe the same behavior?
Can you post the link to the OS image that you are using, so that I can try to replicate the error?