Please do not post a support request without first reading and following the advice in

Wiring SNES controller front to ControlBlock

  • Hi there,

    today I soldered wires to my SNES controller front to connect it to ControlBlock. While testing the controller front circuit before soldering, I discovered that P1 GND and P2 GND are already connected. Same applies to P1 VCC and P2 VCC. So my question is, do I really need to wire 2 additional wires to P2 GND and P2 VCC to connect them to ControlBlock? Or can I just skip these two, as they should be connected anyway?

    I hope I made myself clear.

    Thanks for your help!

  • Global Moderator

    If I understand correctly, it should be ok to skip P2 GND and P2 VCC.

  • Thanks for your reply. As mentioned by various other users it works without any flaws!


Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.

Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.