On the configure controller section I get so far and it locks up
-
When configuring my controller in a new retropie setup, I get so far down the list and it locks up. Then for some reason I get on screen gobbledegook and a flashing cursor. I do not speak the lingo, the nearest I've been to "Python" is Earthworm Jim.
What am I supposed to do next? -
@pickles Need a bit more information, as usual.
ES version, type of controller, are you running the image from the site (or another pre-made image), etc.
An image may help both of how far you get as well as the flashing cursor screen so we could read any relevant messages.
-
@pjft I am simply trying to configure my controller and open retropie. Managed to configure but on the next boot I had to re configure, and my wifi connection had also disappeared. Go figure???
-
@pickles I strongly suspect a faulty SD card. It's known that they get into a read-only state when they're approaching their end.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.