Retroflag NESPi Case - Soft Power & Reset Hack
-
https://i.imgur.com/4E40qB1.jpg
https://i.imgur.com/YygmAy3.jpgThe diodes are facing the right ways, to make sure the mosfet or the switch board that I soldered to doesn't get shorted out by the USB/Ethernet board above it put electrical tape on them and I made sure it didn't make any pins/wires touch each other. I included a picture what how I cut the traces.
-
@ilackiq I'd be willing to bet that the traces are still connected, although you can not really tell one way or the other from your photo. Did you take photos of everything without all the tape on it? I can't really give any advice beyond what I have without seeing everything.
-
@yahmez said in Retroflag NESPi Case - Soft Power & Reset Hack:
@ilackiq I'd be willing to bet that the traces are still connected, although you can not really tell one way or the other from your photo. Did you take photos of everything without all the tape on it? I can't really give any advice beyond what I have without seeing everything.
https://imgur.com/a/mPjh4
Album for them all -
Why is your orange cable connected to +5V of the fan?
-
@snarc said in Retroflag NESPi Case - Soft Power & Reset Hack:
Why is your orange cable connected to +5V of the fan?
What are you talking about? The only orange cable I used was connecting the two + pins on the switch board. There is another cable that looks orangesh-brown that I used to connect the switch board to the mosfet.
-
I meant that picture: https://imgur.com/YygmAy3
-
@snarc said in Retroflag NESPi Case - Soft Power & Reset Hack:
I meant that picture: https://imgur.com/YygmAy3
Oh that was the hardware test. It's been removed
-
@ilackiq try removing the pi completely. Nothing connected. Make sure the power switch is off, then plug in the power to the back of the case. Does the led come on?
-
My reset button is isolated and NESPi turns on and off fine. Reset button is on GPIO 5 and grounded. After I installed the shutdown.py script (curl...|bash), my Retropie boots to the 4 raspberries and then shuts down. I tried to get it to boot in safe mode but can't get to a CLI. Any help is appreciated, thanks.
-
It was the wrong shutdown script that caused the shutdown on startup.
-
@druz it is possible to replace the mosfet tcp8114 with another one more easy to find, actually I live in dominican republic here is really rare to find these spesific part, can you please help me
-
@elvycoll Consider to buy a NESPi+ case
Maybe you can buy a Pimoroni SHIM instead...
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.