Screen bleeding over!
-
Hey all, I have an arcade cabinet that I am using a Raspberry Pi 3 to power. I have everything set up pretty well, but I have had a very hard time getting the right resolution for the TV. I am using a HDMI to RCA adapter. I have tried adjusting both the settings for the emulator and the settings for the pi. I am only using MAME. I am not trying to emulate anything else.
I am new to this, any suggestions you can throw out at me would be HUGE. I am at the point of pulling out my hair. haha.
Please forgive me, I am new to these forums and got overwhelmed while looking. -
@ironj679 Look in
/boot/config.txtChange your overscan setting from 1 to 0 or the other way around. This just depends on your monitor.
If it still off there are 4 individual overscan settings for each side of the screen. Have a play about with these. Remove the # before to activate. After any change you will need to reboot to invoke the changes made.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.