No Sound 3.5mm Jack

[fastlowrex]

I have been running my retropie via HDMI connection to TV with no issues. I am now using a monitor with DVI connection and sound via 3.5 jack on the PI. The sound works for about a 1 minute or 2 then stops and will only work agin if I restart system. I have read forum post after forum post. I have change config files etc and every single thing I tried does not fix the issue. Please, please help! I am desperate.

[fastlowrex]

Here is my config:

For more options and information see

http://www.raspberrypi.org/documentation/configuration/config-txt.md

Some settings may impact device functionality. See link above for details

uncomment if you get no picture on HDMI for a default "safe" mode

#hdmi_safe=1

hdmi_ignore_edid_audio=1

uncomment this if your display has a black border of unused pixels visible

and your display can output without overscan

disable_overscan=0

uncomment the following to adjust overscan. Use positive numbers if console

goes off screen, and negative if there is too much border

#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

uncomment to force a console size. By default it will be display's size minus

overscan.

#framebuffer_width=1280
#framebuffer_height=720

uncomment if hdmi display is not detected and composite is being output

hdmi_force_hotplug=1

uncomment to force a specific HDMI mode (this will force VGA)

hdmi_group=2
hdmi_mode=57

uncomment to force a HDMI mode rather than DVI. This can make audio work in

DMT (computer monitor) modes

#hdmi_drive=2

uncomment to increase signal to HDMI, if you have interference, blanking, or

no display

#config_hdmi_boost=4

uncomment for composite PAL

#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

Uncomment some or all of these to enable the optional hardware interfaces

#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

Uncomment this to enable the lirc-rpi module

#dtoverlay=lirc-rpi

Additional overlays and parameters are documented /boot/overlays/README

Enable audio (loads snd_bcm2835)

dtparam=audio=on

gpu_mem_256=128
gpu_mem_512=256
gpu_mem_1024=256
#overscan_scale=1

[PaulCheffus]

Hi

Have you tried setting the audio to the 3.5mm jack in the RetroPie Audio settings?

Cheers

Paul