here is my config.txt

For more options and information see http://rptl.io/configtxt Some settings may impact device functionality. See link above for details Uncomment some or all of these to enable the optional hardware interfaces

#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

Enable audio (loads snd_bcm2835)

dtparam=audio=on

Pretends no audio formats are supported by HDMI display, forcing all sound out the 3.5mm headphone jack. May not be needed for all HDMI devices

hdmi_ignore_edid_audio=1

forces HDMI mode

hdmi_drive=2

#kernel
kernel=kernel8.img

Additional overlays and parameters are documented /boot/firmware/overlays/README Automatically load overlays for detected cameras

#camera_auto_detect=1

Automatically load overlays for detected DSI displays

#display_auto_detect=1

Automatically load initramfs files, if found

auto_initramfs=1

#hdmi

#resolution

framebuffer_width=1920
framebuffer_height=1080
hdmi_force_hotplug=1
hdmi_group=2
hdmi_mode=82

Enable DRM VC4 V3D driver

dtoverlay=vc4-kms-v3d
max_framebuffers=2

Don't have the firmware create an initial video= setting in cmdline.txt. Use the kernel's default instead.

disable_fw_kms_setup=1

Run in 64-bit mode

arm_64bit=1

Disable compensation for displays with overscan

#disable_overscan=1

Run as fast as firmware / board allows

arm_boost=1

[cm4]

Enable host mode on the 2711 built-in XHCI USB controller. This line should be removed if the legacy DWC2 controller is required (e.g. for USB device mode) or if USB support is not required.

#otg_mode=1

[cm5]
#dtoverlay=dwc2,dr_mode=host

[all]

lr-canary won't install on pi5