DIY Spinner

treki

@UDb23 Do you have a link where I can order the bearing?
Did I understand correctly?
You stuck black paper on the bottom?
Without cutouts?

Edit:
I found, sorry (KFL08 8mm)

UDb23

@shantigilbert Think I still got the files; let me check.

UDb23

@treki I cut out the cardboard to have more or less the same shape of the round moving bottom part of the bearing.

treki

@UDb23 Sorry, my english is terrible. I not understand exactly....
(I cut out the cardboard to have more or less the same shape of the round moving bottom part of the bearing.)
Do you have a photo?
I order:
https://de.aliexpress.com/item/4001214317907.html
https://de.aliexpress.com/item/32713267462.html
https://de.aliexpress.com/item/33036805774.html
and I use a cheap optical mouse from pearl.ch
Is this ok?

UDb23

@treki Cardboard should be applied like this (red area)

If the knob and bar you bought are fitting the bearing they look good to go.

treki

Cardboard should be applied like this (red area)
No lamella needed? The optical mouse understood this like a black table?
Cool ^^

UDb23

@treki Yes. Just make sure cardboard is not too thick; should be able to rotate freely.

treki

Yes. Just make sure cardboard is not too thick; should be able to rotate freely.

That is clear. Thank you
Bombastic idea from you ^^

Can I then ask you if I have a issues?

PS:
www.ltspiceusers.ch is my own forum. Is for LTspice and electronics (german).
You are welcome for register.

UDb23

The chinese says: No support for Raspberry :(
Can I then ask you if I have a issues?

It seems that needs a specific arcade1up controller; without it won't work.

UDb23

@shantigilbert
here you got my 3d source files. Have fun!

shantigilbert

@shantigilbert
here you got my 3d source files. Have fun!

Thank you!

treki

ATM I willbuild a new control.E-Limitatot......Sanwa ist switchet to GND!

A normaly circuit is GND to Joxsticj etc

ClassicGMR

Guy over on AtariAge did 2 sets of these already and is working on a 3rd set now. I bought one of each run and they work great. :)

treki

treki

It works ^^

I soldered 2 wires for the button.

treki

Thx for this idea/tutorial ^^

calom

@treki hi, can you tell me what is wires red and black? Thanks

calom

@UDb23 this is great! How use this with a zero delay usb card? Thanks

treki

@treki hi, can you tell me what is wires red and black? Thanks

These are for the (external) button.
At Arkanoid, this releases the ball.

UDb23

@calom You don't need to connect it to zero delay pcb; you use the usb connection of the mouse itself (different usb port on your Pi)