Controller config nightmare

spruce_m00se

yep, I think I have decided that im just going to have to make the most of it,
its a shame that such a great looking front end software cannot handle the controller config properly.
I am looking into launchbox on windows, and it seems to handle it fine, but getting a small cheap windows pc isnt so easy

spruce_m00se

@meleu your joystick config tool worked for me in the end, when installed on a fresh instal from the start.
I am setting up another system and went to instal the joystick selection tool and the instalation procedure has changed,
I have followed your new instructions and get a message about a corrupted script,,,
is there a way to instal it using the old method still?
can we send Pm's on this forum ?

meleu

@spruce_m00se said in Controller config nightmare:

I have followed your new instructions and get a message about a corrupted script

Oh... Please, paste that message here, or post a picture with it.

is there a way to instal it using the old method still?

No, but I can provide it again. First I would like to know what's wrong with the current method.

can we send Pm's on this forum ?

Nop.

spruce_m00se

I will have another go at instaling it later today and take a photo.

thanks,

spruce_m00se

@meleu
it says:
curl: (3) <url> malformed

and then I cant see it in the experimental packages section.
I have tried twice now on a fresh instal downloaded last night.

meleu

@spruce_m00se said in Controller config nightmare:

it says:
curl: (3) <url> malformed

can you paste here the command you are trying to use?

The correct (and written in the README) is:

curl https://raw.githubusercontent.com/meleu/RetroPie-joystick-selection/master/install.sh -o ~/RetroPie-Setup/scriptmodules/supplementary/joystick-selection.sh

I tried here right now and it worked fine.

spruce_m00se

@meleu my only concern is the ~ symbol, my keyboard places it at the top not in the middle . i will not paste as im not using ssh, but I will cuadruple check and get back to you

meleu

@spruce_m00se said in Controller config nightmare:

my only concern is the ~ symbol

You can use /home/pi instead. ;-)

spruce_m00se

@meleu i get the same result using the ~ as with /home/pi

could you post the whole line including the /home/pi just to make sure im not being dumb?
when I hit enter i get several screens of code scroll past, then the curl: (3) <url> malformed statement

spruce_m00se

@meleu ok I have worked it out,
if you set the curl option as -0 (number zero) then you get screens of code, which to someone who doesnt know what they are doing looks correct.
if you set it as -o (lowercase letter o) then you just get the data transfer specs, and the next stage works.
I have now installed it successfully, perhaps you could put a note in your readme for newbies like me so that they dont make that mistake?