PS3 not connecting to Retropie Raspberry Pi 3
-
Hello and good day,
I have retropie 3.8 clean install. I installed the ps3 drives from retropie_setup.sh and I still can't connect. I tried following the instructions after installing the ps3 drivers with the usb cord and still nothing. I looked at my bluetooth status and I get this error :
bluetooth.service - Bluetooth service
Loaded: loaded (/lib/systemd/system/bluetooth.service; enabled)
Active: failed (Result: exit-code) since Fri 2016-06-24 21:39:23 UTC; 12min ago
Docs: man:bluetoothd(8)
Process: 3107 ExecStart=/usr/lib/bluetooth/bluetoothd (code=exited, status=203/EXEC)
Main PID: 3107 (code=exited, status=203/EXEC)Jun 24 21:39:23 retropie systemd[1]: bluetooth.service: main process exited...EC
Jun 24 21:39:23 retropie systemd[1]: Failed to start Bluetooth service.
Jun 24 21:39:23 retropie systemd[1]: Unit bluetooth.service entered failed ...e.
Hint: Some lines were ellipsized, use -l to show in full.When I tried starting bluetooth I got this error:
Job for bluetooth.service failed. See 'systemctl status bluetooth.service' and 'journalctl -xn' for details.
all i want to do is connect my ps3 controller to my retropie
Thank you
-
PS3 doesn't use the built in bluetooth stack (in fact it disables the built in bluetooth stack).
Do you have an original controller or a clone - can you go through the steps you used to pair it ?
-
Hey BuZz,
I did this before on another pi 3 and worked but now I forgot how to man.
Yes it is the original PS3 wireless controller and doesnt require a dongle since im using Retropie 3.8.
I ran the command sudo retropie_setup.sh and went to install the ps3 drivers. Afterwards I went and followed the instructions
where I connected the controller and disconnected it and pressed the middle button to sync. But no luck. I tried installing pi-bluetooth and
still no luck.When I run the systemctl status bluetooth
I get Active: failed ( Result: exit-code) since Fri 2016-06-24 22:06:02 UTC: 15h ago.
Thanks
-
@BuZz
Hey BuZz,I did this before on another pi 3 and worked but now I forgot how to man.
Yes it is the original PS3 wireless controller and doesnt require a dongle since im using Retropie 3.8.
I ran the command sudo retropie_setup.sh and went to install the ps3 drivers. Afterwards I went and followed the instructions
where I connected the controller and disconnected it and pressed the middle button to sync. But no luck. I tried installing pi-bluetooth and
still no luck.When I run the systemctl status bluetooth
I get Active: failed ( Result: exit-code) since Fri 2016-06-24 22:06:02 UTC: 15h ago.
Thanks
-
@wolfzrat Did you ever manage to get this working? I have trouble pairing mine up, too...
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.