YASB (yest another Snes Build)

[Kalidor]

Hi,

It’s all been done before, but a dozen different ways and the information's scattered everywhere.

I have a SNES shell to put my Raspberry Pi 3 into.

I'm going for as stock a look as possible.

Video Out

I’m trying to get my RPi 3 to output to what I call an aerial socket, I believe this may be called RCA or coaxial depending on where you’re from.

It looks like this and would output audio and video:

Can i output to this using this (like I believe you can with the Pi zero
( https://www.raspberrypi.org/magpi/rca-pi-zero/ )

https://www.adafruit.com/product/2793

Power Switch

For the power switch I’m going to use this, and don’t foresee any issues:
https://blog.petrockblock.com/powerblock/

Reset Switch:

I will wire a momentary switch on the GPIO pins that when pressed will exit the emulator and go back to the game selection using this guide:

https://www.reddit.com/r/raspberry_pi/comments/2yw4fn/finally_set_up_retropie_complete_with_a_gpio/cpdhtpu/

(i’ll have to change to pins not taken up by power switch board)

Think that's the correct way to go? anything i would be doing wrong or could do better?

[retroprogrammer]

Looks good