lr-mame2003 won't start after update
-
Hello.
I had a working setup of RetroPie 3.6 running under Raspberry Pi 3.
I didn't update lr-mame2003 since original installation along RetroPie as I didn't have any issues with it.
Lately I've run into some issues with aspect ratio for few roms and when searching for solution I have found information in some thread at this board, that this issue was already fixed. So I've tried updating lr-mame2003 - first from source to get the latest version possible. Since the build process failed I've used install from binary instead.
There were no errors reported. Yet, when I'm trying to launch any game (that was working fine earlier) I'm getting no results and I'm back to EmulationStation after two seconds or so. Runcommand.log shows a lot of "not found" files, while all of them are actually still located inside each rom ZIP file, so it doesn't seem to be a romset mismatch issue.
I'm guessing this might be related to the latest changes of paths used for storing lr-mame2003 configuration files. Or maybe something at runcommand configuration should be changed? Anyway, if I'm right in any of those cases, could anyone please point me which files exactly should be moved from where and to where, as the GitHub pull request referenced at wiki is a bit confusing. Please note I'm using RetroPie 3.6 and not 3.7 as this may affect those locations also.
-
you need to also update retroarch via the same process.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.