“Failed to start load kernel modules” (SOLVED)

cynital

@mitu tu i replaced it and reinstalled xpad and rebooted still doesnt work did i have to update retropie setup script too?

cynital

@mitu did that too i went back and check if line 28 saved and it did, i uninstalled xpad then went to command made sure to save then i went to install xpad again rebooted then try to config it doesnt work

cynital

@mitu i found this if this will help https://retropie.org.uk/forum/topic/3200/afterglow-prismatic-wired-controller-for-xbox-one/3

cynital

Oh and also @mitu this is my controller https://amzn.to/2tOjFI6
The problem might be that you might be looking how to do this other one https://amzn.to/2tCPfsX
They are very similar but one has different firmware i think but its the same company, but ik my controller is still possible to be used on the pi I edited the 28 line like you said and did everything but still doesn’t work

mitu

@cynital Post the dmesg after you updated the driver and rebooted, just to check if the gamepad is now detected as an Xbox controller.

EDIT: I made some modifications, you should try to install it again as I mentioned in https://retropie.org.uk/forum/topic/18378/failed-to-start-load-kernel-modules/34 and reboot, then see if the controller gets detected. If not, execute dmesg | nc termbin.com 9999 and post the link.

cynital

i am trying it again @mitu and if it doesnt work ill post the dmesg

cynital

@mitu it finally works!! thank you so much i revert the changes and booted it up and still works thanks!!!

mitu

@cynital OK, now what you did was install a patched version of the xpad driver, but if you update it, it will install the default driver again and you'll be in the same situation.

I'll submit the patch to the official driver page so it would be included in the future.

cynital

so im going always have to do this or they are going to add it?

mitu

@cynital Let's just give it a bit of time, the patch will probably be accepted.

cynital

@mitu you told them to pacth it?