Installation of Xpad driver failed.

windg

It looks that is affect and the building of lr-swanstation from Retropie-Extra repo. So, if someone want to install this emulator add the arm_64bit=0 to config.txt file, reboot and then try again.

log from fail building : https://pastebin.com/yCkm9L2U

stabicron

@mitu Forgive me if this seems obvious but I do not see where the config.txt file is stored in this thread. Where is it?

windg

This post is deleted!

mitu

@stabicron It's on the boot partition of the sdcard and you also can find it at /boot/config.txt from your running system. You can run

sudo nano /boot/config.txt

to edit the file after you exit EmulationStation.

mitu

@windg said in Installation of Xpad driver failed.:

It looks that is affect and the building of lr-swanstation from Retropie-Extra repo

It's going to affect more than one package, there are quite a few emulators that use uname -m to determine if the system is 32 or 64bit and set the build parameters accordingly. There's no point in keeping track of them, since running a mixed 64/32bit kernel/userspace is not a very common configuration.

stabicron

@mitu Thank you. Just tried it and worked for xpad and a couple of the others that were running into the same thing

MaXxOnRP

@mitu Thanks for your help. Read it yesterday, tried it and it helped my build too. Best Regards

windg

It looks that the change that was added to Raspi Buster Lite, was a mistake. Soon an update will fix this.

mitu

@windg said in Installation of Xpad driver failed.:

Soon an update will fix this

The updated packages (kernel/firmware-bootloader) for have been released for Buster, the modifications suggested earlier to config.txt should not be needed anymore.

MaXxOnRP

@windg Nice.