My SNES Build

ruckage

@jackal123uk
Thanks, I'll get one of those ordered. I may see if it's possible to shorten the cable when I get it.

ruckage

I got my cable, I bought it from Pimoroni in the end as it appears to be the same as yours but much shorter (15cm).
I've fitted it into my case and it works perfectly :)

Here's a link to my build thread to show how I Secured it in place: https://retropie.org.uk/forum/topic/11681/super-famicom-snes-build/45

ahaertig

@jackal123uk said in My SNES Build:

I'm turning my attention to the next version of my pcb, I've decided to go easy on myself for now and leave the USB hub contained in a cartridge although this means I've now to mount the 62 pin cartridge connector onto the pcb. Below are my measurements of the original board - I know the position of the reset switch and the mounting holes to the right are correct as I used these on the last version of my board. Anyone know if there's a more official version of this type of drawing or something that's at least been verified?

It seems like you manage to find information about the SNES board. Do you mind sharing it with us? I'm working on a similar PCB in combination with a ControlBlock for my custom SNES build.
In addition can you also share the files of your custom PCBs?

Best, Alexander

jackal123uk

@ahaertig I didn't find the information per se, I just measured board with a set of digital callipers and modelled it in AutoCad. Pretty accurate as you can see from the photos of my build - everything fits perfectly.

Here's the CAD file for the board and here's the gerber files for the PCB - hope they help you out.

ahaertig

@jackal123uk Thanks for your quick reply and for providing the files! I only had a chance to take a look at it today.
Unfortunately the CAD and gerber files do not match. As the gerber files represent your "SNES-RPi Interface v3", which you described in your posts above and I'm interested in, the CAD files seem to be another project called "SNES Controller PCB". In case you still have the CAD files for the SNES RPi Interface, could you also provide them?
Just to assure we're on the same page: what I'm interested in are the PCB footprints of the Reset switch and the 11-pin flat cable frontpanel socket, so I can design a custom PCB.

jackal123uk

It's been a while but I've finally had a little more time to play with this project. It was always planned to integrate the USB hub onto the main board but I'm not massively experienced in board design or SMD soldering. As such, I thought I'd start easy with just the hub in the cart.

Quite surprisingly it actually works! This paves the way for my next project which is a tad more demanding on the board design front.

If anyones interested in doing the same I used the FE1.1S hub IC which incidentally is the same as was installed in the purchased hub I originally used. In both cases it seems to play well with the Pi zero.