DIY Spinner
-
@shantigilbert Think I still got the files; let me check.
-
@treki I cut out the cardboard to have more or less the same shape of the round moving bottom part of the bearing.
-
@UDb23 Sorry, my english is terrible. I not understand exactly....
(I cut out the cardboard to have more or less the same shape of the round moving bottom part of the bearing.)
Do you have a photo?
I order:
https://de.aliexpress.com/item/4001214317907.html
https://de.aliexpress.com/item/32713267462.html
https://de.aliexpress.com/item/33036805774.html
and I use a cheap optical mouse from pearl.ch
Is this ok?My bartop: https://www.ltspiceusers.ch/threads/arcade-bartop-im-selbstbau.457
-
@treki Cardboard should be applied like this (red area)
If the knob and bar you bought are fitting the bearing they look good to go.
-
@UDb23 said in DIY Spinner:
Cardboard should be applied like this (red area)
No lamella needed? The optical mouse understood this like a black table?
Cool ^^ -
@treki Yes. Just make sure cardboard is not too thick; should be able to rotate freely.
-
@UDb23 said in DIY Spinner:
Yes. Just make sure cardboard is not too thick; should be able to rotate freely.
That is clear. Thank you
Bombastic idea from you ^^https://de.aliexpress.com/item/1005001309430437.html
The chinese says: No support for Raspberry :(Can I then ask you if I have a issues?
PS:
www.ltspiceusers.ch is my own forum. Is for LTspice and electronics (german).
You are welcome for register. -
@treki said in DIY Spinner:
The chinese says: No support for Raspberry :(
Can I then ask you if I have a issues?It seems that needs a specific arcade1up controller; without it won't work.
-
@shantigilbert
here you got my 3d source files. Have fun! -
-
ATM I willbuild a new control.E-Limitatot......Sanwa ist switchet to GND!
A normaly circuit is GND to Joxsticj etc
-
Guy over on AtariAge did 2 sets of these already and is working on a 3rd set now. I bought one of each run and they work great. :)
-
I order
https://www.campz.ch/mcnett-aquapak-epoxy-reparaturharz-236208.html
Is this ok? -
It works ^^
I soldered 2 wires for the button.
-
Thx for this idea/tutorial ^^
-
@treki hi, can you tell me what is wires red and black? Thanks
-
@UDb23 this is great! How use this with a zero delay usb card? Thanks
-
@calom said in DIY Spinner:
@treki hi, can you tell me what is wires red and black? Thanks
These are for the (external) button.
At Arkanoid, this releases the ball. -
@calom You don't need to connect it to zero delay pcb; you use the usb connection of the mouse itself (different usb port on your Pi)
-
@UDb23 its possoble on pi zero2 with a usb hub as only have one port? Thanks
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.