USB audio incompatible with mame4all?

mitu

How did you configure the USB soundcard ? Did you also disable the PI's native audio ?

t3stin

@mitu when I disabled the onboard card I was getting various errors so I re-enabled it and switched the default order so the usb one is first (0) and onboard (1).

mitu

From what I see, mame4all is picking up only the 1st (default) audio card. Post an emulator log, maybe that would show the error (/dev/shm/runcommand.log).

t3stin

@mitu so I get this
Have tried changing the sample rate to 48000hz in mame.cfg (I assume in the right directories) but still says the same - requested 44100hz etc.

mitu

Either the rom is faulty (but since it works with lr-mame2000 that may not be the case) or mame4all doesn't like the the ALSA setup.
There's an extensive post here about a similar setup. Try adapting the .asoundrc file to your setup and see if you get mame4all to work.

t3stin

@mitu will take a look at the post but literally all the roms worked in mame4all until adding the USB audio, if I remove it all the roms work again.

t3stin

@mitu ok besides the rom I tested with earlier most others seem to work again with those changes but I'm still unbelievably getting no audio 😭 would it be worth checking the runcommand log again or will it be blank as the rims work? Finally should card "U012529205" mentioned below be unique or would this be generic? Not sure how I find out what I replace that with and I appreciate all the help your giving!```
}
pcm.usb {
type hw
card "U012529205"
format S16_LE
}

mitu

@t3stin Try listing the cards with aplay -l, yours may have a different name.

t3stin

@mitu so I get the right answer here's a few screenshots if you're able to decipher? In ES I have card as sysdefault, device as speaker and 0MX as ALSA:HW:0,0

t3stin

@t3stin

t3stin

@t3stin

mitu

Sounds like the name is 'USB PnP Sound Device'.

t3stin

@mitu ROMs load, no errors in run command, when I run a test wav file the light on the usb sound card flashes yet I still have nothing coming out of the speaker (which was new)...never realised it would be so difficult to get some sound out of this thing! Should I just give up and play in silence? 😐

grant2258

@t3stin

check with alsamixer to see what the volume it set too

t3stin

@grant2258 I had checked there, it was set to 100

grant2258

can you post the output of

amixer -M
and
amixer

t3stin

@grant2258 see attached

grant2258

if you look at mono playback it appears to be off (mic) open alsamixer again use the leftt and right arrow keys to check if anything is muted or off also what is your sound.

edit:

Check if you have a ~/.asoundrc file in your user home directory; it will override settings in /etc/asound.conf

more info here

https://www.alsa-project.org/main/index.php/Asoundrc

t3stin

@grant2258 all was fine there.....would you believe out of curiosity I found out some really old headphones and the sound was blaring from them - apparently brand new speaker DOESNT work!! Thanks for all your help guys.

grant2258

Nasty the speaker wasnt working glad you got it fixed!