N64 crashes after 10 min
-
@endersenigma who told you to give 512MB RAM to the GPU?
-
@jonnykesh
no change in performance, even the higher demand emulators from 256 to 512. More is better if you are checking to see where the bottleneck is. Since this is a great way to see if its a ram issue by giving more to the gpu, its a great way to troubleshoot if the amount of ram is an issue. My tests show its not in ram or gram. It doesnt seem to be in processor capability either as I have dumbed that down as well in my tests with minimal change till i get into the triple digits. I'm guessing its just a GPU limitation since I have ruled out just about everything else. -
@endersenigma who told you that more is better? You are robbing your CPU of memory. Your GPU will never come close to using 512mb of ram. I'm not saying it's the solution to your current issue but you should leave it a 256.
-
@quicksilver
Is there a PS you would recommend since you had this exact same issue before?If you hold your Pi out the window while driving 40+ mph, the performance is improved significantly.
True story.
-
@quicksilver
i had it set at 256, then 512 and now im running it at 640 just for kicks. No change in performance better or worse. I have also gone up and down on my proc speed (with my gram set lower of course) and the issue still persists. I dont even think the 3D freq setting is having much of an effect bringing it from 350-450 either. Not sure what is causing this stupid freeze problem in only one emulator. Since your case and possibly power supply seem to be behind your issue, I will try a new PS as soon as I can order one.If you hold your Pi out the window while driving 40+ mph, the performance is improved significantly.
True story.
-
@endersenigma https://www.amazon.com/Mackertop-HSTNN-LA43-PA-1150-22HA-779573-001-761247-002/dp/B01HB44IE6
This is the one I switched to. However, even with this adaptor I still had issues until I took my pi out of my nespi case. Have you tried disconnecting your fan? (Again, no overclock until you figure out the issue).
-
@endersenigma increasing your clock speeds is NOT going to help with stability. Restore your default clock speed and mem split and leave it there until you figure out the issue.
-
@quicksilver
yep, all overclocks have been disabled and gram has been dropped back down to 256. I have disconnected the fan, no change. My old case didnt have a fan (i rigged one up that was powered externally, heat wasn't the issue, had the freeze before and after the fan).Running stock config currently, ordering a new PS. I am skeptical about it being the power supply as it doesn't act like a power supply issue from other non-pi systems i have worked on. Only way to know is to try a different one out. Any other ideas in the mean time? Other than enjoy N64 13.5 minuets at a time? :P
-
I am almost curious if I should wipe that version of the N64 and install clean from binary, and see if the problem replicates prior to installing from source.
-
@endersenigma it's worth a shot. Although that didn't fix my issue. Was mupen64-glide ever stable for you in the past?
-
@quicksilver
Only mario 64. Instead of crashing it just slows down for about 10 seconds then goes back to normal. every other game I have crashes at the 13-15 minute mark. Exactly as you described it in your post. I have only had my PI 4 days and N64 has always been unstable. -
@quicksilver
would 4.3amp fry the pi3? I have one of those at 5v 4.3 ampIf you hold your Pi out the window while driving 40+ mph, the performance is improved significantly.
True story.
-
@endersenigma I wouldn't use that. I seriously doubt amperage is your issue because you don't have a lot hooked up to your pi.
-
Did a complete uninstall of the N64 emulator, rebooted, installed N64 from Binary, rebooted. Same problem. updated from source. rebooted, same problem. Outside of doing a complete reformat of my pi and starting from scratch, I am not sure what else to do.
@dankcushions
Do you have any input? I have tried everything I know how to try. Awaiting new power supply as we speak, but it doesn't act like any power supply issue from my experience.If you hold your Pi out the window while driving 40+ mph, the performance is improved significantly.
True story.
-
@endersenigma said in N64 crashes after 10 min:
@quicksilver
would 4.3amp fry the pi3? I have one of those at 5v 4.3 ampexcess amperage does not damage electronics.
the voltage needs to be correct and the specified minimum amperage needs to be met. unlike excess voltage, excess amperage can never be a problem -- t just means there is more power to draw on than the device might need.
-
@markwkidd
good to know. Thanks. -
@endersenigma said in N64 crashes after 10 min:
@dankcushions
Do you have any input? I have tried everything I know how to try. Awaiting new power supply as we speak, but it doesn't act like any power supply issue from my experience.like i said before, if the overclocks are all removed, and it's not a power issue, a software bug can be reported, but my issue with this is that if there's a bug then everyone should be getting it, since we're (mostly) all on the same hardware. i won't have a chance to test n64 on a pi3 for a while, but unless someone else is getting this issue then i would suspect power is the culprit, as there's not much else left!
-
@quicksilver
You guys are all using n64glide right? -
@endersenigma said in N64 crashes after 10 min:
@quicksilver
You guys are all using n64glide right?Yes
-
@quicksilver
new power supply arrives tomorrow, will update.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.