EmulationStation Controller Configuration Not Saving
-
Hi, Everyone,
I apologized but I've searched high and low and can't find an answer for this one. I'm running EmulationStation through OpenELEC on a Raspberry Pi 3 using iNNEXT Super Nintendo USB Controller.
I continually go into the configuration for the controller in EmulationStation and set all the buttons appropriately. Whenever I do this then load a game it immediately reverts back to the default settings. It never saves or remembers the inputs as I have set them. Basically the only thing that is wrong is that SELECT/START are reversed and A/B are reversed. I can play everything fine but, obviously, it's a little frustrating after 30+ years being used to the controls of a game. :-)
There must be something I'm doing wrong but I'll be darned if I can figure out what it is.
Any help on this matter would be greatly appreciated. Thanks so much!
-
@chefelf Please provide the information asked in https://retropie.org.uk/forum/topic/3/read-this-first, but since you're not running a RetroPie system (EmulationStation is just a frontend included in RetroPie) - wouldn't it be better asking in the OpenELEC forums first ?
-
I'm sorry about that. Was trying to find the right spot to ask this question. Will check out OpenELEC.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.