N64 crashes after 10 min
-
@quicksilver
i had it set at 256, then 512 and now im running it at 640 just for kicks. No change in performance better or worse. I have also gone up and down on my proc speed (with my gram set lower of course) and the issue still persists. I dont even think the 3D freq setting is having much of an effect bringing it from 350-450 either. Not sure what is causing this stupid freeze problem in only one emulator. Since your case and possibly power supply seem to be behind your issue, I will try a new PS as soon as I can order one. -
@endersenigma https://www.amazon.com/Mackertop-HSTNN-LA43-PA-1150-22HA-779573-001-761247-002/dp/B01HB44IE6
This is the one I switched to. However, even with this adaptor I still had issues until I took my pi out of my nespi case. Have you tried disconnecting your fan? (Again, no overclock until you figure out the issue).
-
@endersenigma increasing your clock speeds is NOT going to help with stability. Restore your default clock speed and mem split and leave it there until you figure out the issue.
-
@quicksilver
yep, all overclocks have been disabled and gram has been dropped back down to 256. I have disconnected the fan, no change. My old case didnt have a fan (i rigged one up that was powered externally, heat wasn't the issue, had the freeze before and after the fan).Running stock config currently, ordering a new PS. I am skeptical about it being the power supply as it doesn't act like a power supply issue from other non-pi systems i have worked on. Only way to know is to try a different one out. Any other ideas in the mean time? Other than enjoy N64 13.5 minuets at a time? :P
-
I am almost curious if I should wipe that version of the N64 and install clean from binary, and see if the problem replicates prior to installing from source.
-
@endersenigma it's worth a shot. Although that didn't fix my issue. Was mupen64-glide ever stable for you in the past?
-
@quicksilver
Only mario 64. Instead of crashing it just slows down for about 10 seconds then goes back to normal. every other game I have crashes at the 13-15 minute mark. Exactly as you described it in your post. I have only had my PI 4 days and N64 has always been unstable. -
@quicksilver
would 4.3amp fry the pi3? I have one of those at 5v 4.3 amp -
@endersenigma I wouldn't use that. I seriously doubt amperage is your issue because you don't have a lot hooked up to your pi.
-
Did a complete uninstall of the N64 emulator, rebooted, installed N64 from Binary, rebooted. Same problem. updated from source. rebooted, same problem. Outside of doing a complete reformat of my pi and starting from scratch, I am not sure what else to do.
@dankcushions
Do you have any input? I have tried everything I know how to try. Awaiting new power supply as we speak, but it doesn't act like any power supply issue from my experience. -
@endersenigma said in N64 crashes after 10 min:
@quicksilver
would 4.3amp fry the pi3? I have one of those at 5v 4.3 ampexcess amperage does not damage electronics.
the voltage needs to be correct and the specified minimum amperage needs to be met. unlike excess voltage, excess amperage can never be a problem -- t just means there is more power to draw on than the device might need.
-
@markwkidd
good to know. Thanks. -
@endersenigma said in N64 crashes after 10 min:
@dankcushions
Do you have any input? I have tried everything I know how to try. Awaiting new power supply as we speak, but it doesn't act like any power supply issue from my experience.like i said before, if the overclocks are all removed, and it's not a power issue, a software bug can be reported, but my issue with this is that if there's a bug then everyone should be getting it, since we're (mostly) all on the same hardware. i won't have a chance to test n64 on a pi3 for a while, but unless someone else is getting this issue then i would suspect power is the culprit, as there's not much else left!
-
@quicksilver
You guys are all using n64glide right? -
@endersenigma said in N64 crashes after 10 min:
@quicksilver
You guys are all using n64glide right?Yes
-
@quicksilver
new power supply arrives tomorrow, will update. -
@quicksilver @dankcushions
New power supply, same problem.
I am just going to use a different emulator, even if they look worse maybe they will at least be playable. Cheers!Thanks for all the help.
-
@endersenigma which power supply did you go with?
-
@quicksilver
The one you linked earlier in the post. -
@endersenigma strange that we should have the same issue and I was able to resolve mine. I wish I could think of something else for you to try.
Contributions to the project are always appreciated, so if you would like to support us with a donation you can do so here.
Hosting provided by Mythic-Beasts. See the Hosting Information page for more information.