Instead of using the "enable_uart=1" line in config.txt, I found out it might be more optimal to activate the voltage on pin 8 from inside the retropie>raspi-config>interfacing options>Serial.
@ldonohue85 sweet jelly that's a big one wish I had a big one. yeah you ok with previous advice I thought for a sec you was going crt 15hz. But yeah all good
I did notice something else. Before I flash the image file to the SD card, the format of the SD card is in fact FAT32. After the image is written, it is FAT (not 32). Could this be an issue?
@jabbafeet I don't expect other people's numbers to be useful for other cases, as different TV sets have different requirements. I'd encourage you to follow the steps mentioned in the previous posts and understand what ranges work for you in the end. In one monitor I have I don't need these, in another one I end up needing negative values for some reason.