Ps: the daphne ported i metioned https://github.com/DavidGriffith/daphne
As for fs-uae i will give amiga a dedicated sd card (my 32gb card will not support erverything) with amibian, but great to see fs-uae

@Chillimonster said in [Lr-mame2003 trackball issues. Not always seen](/forum/topic/3876/lr-

When the trackball is not recognised i get no response from the cat / dev/input/mice command,and when it is detected i get the usual character output.

Going to try re-imaging the card incase i've messed something up, and have another play later.

Not a bad thing to try, but if this was image corruption it wouldn't be changing. I wonder if maybe the USB connection is intermittent or perhaps draining the power to a point where it stops working. Because the 'test' revealed that when it's not working, linux itself isn't even getting the inputs. I've seen similar issues when plugging in too many devices without a good power supply, or not using a powered USB hub.

So I believe the issue is that emulationstation won't allow the video from mplayer to play over it. I've tried adding --ontop to the line in order to have it play over emulationstation, but that program always seems to be over mplayer, and I can only hear the audio of the video after emulationstation starts.

@tehswiftone Ah, gotcha.

Sounds similar to the issue I had before I configured my controller for Dreamcast.

Scroll to the bottom: https://github.com/retropie/retropie-setup/wiki/Dreamcast

@BuZz git is something I know very little about, but I think I figured out how to get the versioning. Thanks :)

@BuZz Thanks. It was worth a shot.

I didn't see anything on Attract-Mode's documentation about it there either. :(

Thank you for the help, roms launch now after following directions.

https://github.com/RetroPie/RetroPie-Setup/wiki/First-Installation#controller-configurations

if you run out of buttons just hold down a button to skip each unused button.

@PopetheRevXXVIII which emulator are you using for nes? Fceumm cuts off on both sides on every game. Nestopia displays correctly.

I think you will be better off asking here:
https://forum.recalbox.com/

I've not really looked at the structure of Recalbox before.

To make the microsd card a bit more accessible for removal, I've ordered one of these:

http://www.ebay.co.uk/itm/182218715289

I'll post an update when it arrives to let you know if it works okay.

@bfenty The script runs automatically on boot, so you just reboot the normal way.

So an update here after some playing around I am noticing that the runcommand is not saving the any video resolutions I change. I thought it was only changing resolution thus the aspect ratio wasn't changing but apparently it should also be changing aspect ration since its in the options. When I press select on my DS3 to change an option it doesn't see to show the option change in the parenthesis. So I think this is actually a runcommand issue?

@dankcushions my rom is daredevil

Thanks again, I now have a compatible rom set :-)

Kev

@jmac If you're on RPI3 recommended is a 2.5A power supply.